[Lcdproc] output problem with Matrix Orbital LK202-25 at Version 0.5.0

[RavensWorld@gmx.de]

Hi List,

thanks a lot! 

Now it's working fine.
It was a problem with the configuration of the MtxOrb-driver.
I tested a lot of combinations. Next I can find the min. difference between my config and the default-config, but not today - going for weekend.

see you

-------- Original-Nachricht --------
Datum: Fri, 15 Sep 2006 17:28:02 +0200
Von: Peter Marschall <peter@adpm.de>
An: lcdproc@lists.omnipotent.net
Betreff: Re: [Lcdproc] output problem with Matrix Orbital LK202-25 at Version 0.5.0

> Hi,
> 
> I can't believe the driver is not working at all.
> 
> On Thursday, 14. September 2006 16:24, RavensWorld@gmx.de wrote:
> > [MtxOrb]
> > Device=/dev/ttyS1
> 
> Is your LCD connected to /dev/ttyS1 ?
> This is usually the 2nd serial port.
> Did you try with other settings ?
> 
> > Size=20x2
> > Backlight=yes
> > Contrast=800
> > Speed=19200
> 
> Did you try with other speed settings ?
> 
> > Type=lkd
> >
> > LeftKey=A
> > RightKey=B
> > EnterKey=C
> > UpKey=D
> > DownKey=E
> > EscapeKey=F
> >
> > keypad_test_mode=no
> 
> What does the LCDd server say when you call it with the parameters
> -f1 -s0 -r5 ?
> Only the 1st ~20 lines are relevant.
> 
> Regards
> Peter
> 
> -- 
> Peter Marschall
> peter@adpm.de
> _______________________________________________
> LCDproc mailing list
> LCDproc@lists.omnipotent.net
> http://lists.omnipotent.net/mailman/listinfo/lcdproc

-- 
"Feel free" - 10 GB Mailbox, 100 FreeSMS/Monat ...
Jetzt GMX TopMail testen: http://www.gmx.net/de/go/topmail